LOC often indicates that the control panel has been locked to prevent accidentally turning on (or off) the oven. This is useful when you clean the control panel (or have small children). Look on the appliance for a notation to press and hold a touch pad (or pair of them) to engage the control panel lock.
If the range control panel is blank, the oven control board could be the problem—the oven might not heat either. This DIY repair guide and video show how to replace the range oven control board easily, in 30 minutes or less.
If the touch pads on your microwave oven do not respond but the display lights up, the problem may be with the control board. The control board generates a low voltage that is supplied to the membrane switch. When a pad is depressed, the voltage signal is switched back to the control board.
power to oven. (A) Do not operate or allow oven to be operated with door open. (B) Make the following safety checks on all ovens to be serviced before activating the magnetron or other microwave source, and make repairs as necessary: • Interlock operation • Proper door closing • Seal and sealing surfaces (arcing, wear, and other damage)
Cafe C2S900P2MS1 30 Inch Slide-In Dual Fuel Smart Range with 6 Sealed Burners, 5.7 cu. ft. Oven Capacity, Warming Drawer, 21K Triple Ring Burner, Edge-to-Edge Cooktop, True European Convection, Temperature Probe, LED Control Panel, Self-Clean Racks, ADA Compliant and Star-K Certified Sabbath Mode: Stainless Steel
Jul 18, 2019 · If features such as the oven’s timer are not working, you may just think it’s a minor problem, but it could actually be telling you that something’s seriously wrong with the control board. The broiler not working could also spell bad news for the control board installed in your oven. Lastly, c ertain oven error codes may be displayed on the oven if there’s an issue with its control board. These codes typically start with the letter “F.” What Are the Tools You Need to Repair an ...
Remove the ribbon cable from the keypad to the control board at the control board. Clean the edge connector. If it is the type where there is not a connector just the insulation is removed, it can be cleaned with a pencil eraser. Do not use an ink eraser as it is too abrasive. Check the tracks in the ribbon cable for hairline cracks.